1. It is recommended to remove foam insert after use.  Condensation may accumulate inside lower plastic body and freeze in cold environments.  This will not harm lower plastic body or foam inserts, but it may deter the seal between foam insert and lower plastic body.  This will also allow the foam impressions to heal from water sealing device.  Lifespan of foam insert will greatly increase because of healing time.  It will keep foam like new for a long, reliable service life.
2. It is recommended to use a twisting motion when inserting foam.  Lower plastic body utilizes and air void to allow adjustment by changing volume.  A vapor lock may occur when inserting foam.  Twisting foam allows air to escape – eliminating the chance of vapor lock.  The twisting motion will greatly reduce effort of foam insertion.
3. When cutting float to make the lower plastic body removable, we recommend cutting through the component at an angle.  It is also recommended to use a very sharp knife to create the slimmest slot.  The angled cut and slim slot makes it very difficult for the line to get through resulting in float falling off.  Our video on the website depicts these recommendations.

NITE-BITE™ Helpful Hints:

1. Optimum brightness is achieved by using high intensity (LED) lighting when charging component.
2. This product is recommended for use with NITE-BITE™ white foam inserts for optimum light reflection and visibility.
3. For extended component life, it is recommended to store luminous components out of direct sunlight when not in use.